D-Link DXS-3600 Series Cli Reference Manual page 1178

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
BY default, this option is disabled.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to turn on or turn off the IPv6 RIP debug function while the global debug function has
been turned on before.
Example
This example shows how to turn on the IPv6 RIP debug function.
Switch# debug ipv6 rip
Switch#
94-13 debug ipv6 rip interface
This command is used to turn on the IPv6 RIP interface state debug switch. To turn off the IPv6 RIP
interface state debug switch, use the no form of this command.
debug ipv6 rip interface
no debug ipv6 rip interface
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to turn on or turn off the IPv6 RIP interface state debug switch. When the IPv6 RIP
interface state changes or some events happen to change the interface state, the debug information will
printed if the IPv6 RIP debug function is turned on.
Example
This example shows how to turn on the IPv6 RIP interface state debug switch.
Switch# debug ipv6 rip interface
Switch#
The RIPng interface vlan1 has changed the link state to UP
1173