Dot1Q Tunneling Ethertype - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-if-xconn)#
118-3

dot1q tunneling ethertype

This command is used to configure the TPID of the VLAN tag to be added or changed for the
encapsulated packet.
dot1q tunneling ethertype VALUE
no dot1q tunneling ethertype
Parameters
VALUE
Default
By default, this value is 0x8100.
Command Mode
Xconnect Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the TPID of the VLAN tag. If the VLAN mode is addvlan or
changevlan, the TPID of the modified VLAN tag will be set to the configured value. The command can
only be applied on a PW of the type is tagged.
Example
This example shows how to configure the 802.1Q tunneling TPID to 0x88a8 of a PW.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# xconnect 130.1.1.2 2 encapsulation mpls
Switch(config-if-xconn)# dot1q tunnel ethertype 0x88a8
Switch(config-if-xconn)#
118-4 mpls label
This command is used to assign the local label and the remote label used by the manual PW.
mpls label LOCAL-LABEL REMOTE-LABEL
no mpls label
Parameters
LOCAL-LABEL
Specifies the outer TPID for the service VLAN tag. The value is in
hexadecimal form. The range is from 0x1 to 0xFFFF.
Specifies the incoming label by which the packets of the PW are
1366