D-Link DXS-3600 Series Cli Reference Manual page 1238

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the SNNP UDP port number on the switch. The agent will listen to the
SNMP request packets on the configured service UDP port number.
Example
This example shows how to configure the SNMP UDP port number.
Switch# configure terminal
Switch(config)# snmp-server service-port 50000
Switch(config)#
101-21 snmp-server response broadcast-request
This command is used to enable the server to response to broadcast SNMP GetRequest packets. Use
the no form of this command to disable the response to broadcast SNMP GetRequest packets.
snmp-server response broadcast-request
no snmp-server response broadcast-request
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable or disable the server to response to broadcast SNMP GetRequest
packet. NMS tools would send broadcast SNMP GetRequest packets to discover networks device. To
support this function, the response to the broadcast get request packet needs to be enabled.
Example
This example shows how to enable the server to respond to the broadcast SNMP get request packet.
Switch# configure terminal
Switch(config)# snmp-server response broadcast-request
Switch(config)#
101-22 snmp trap link-status
This command is used to enable the notification of link-up and link-down events that occurred on the
interface. Use the no form of this command to disable the notification.
1233