D-Link DXS-3600 Series Cli Reference Manual page 1204

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Usage Guideline
Use the primary command to specify a given trust-point as primary. This trust-point can be used as
default trust-point when the application doesn't explicitly specify which certificate authority (CA) trust-point
should be used. Only one trust-point can be specified as the primary. The last trust-point specified as the
primary will overwrite the previous one.
Example
This example shows how to configure the trust-point "TP1" as the primary trust-point.
Switch# configure terminal
Switch(config)# crypto pki trustpoint TP1
Switch(ca-trustpoint)# primary
Switch(ca-trustpoint)#
98-6 show crypto pki trustpoints
This command is used to display the trust-points that are configured in the switch.
show crypto pki trustpoints [TRUSTPOINT]
Parameters
TRUSTPOINT
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If no parameter is specified, all trust-points will be displayed.
Example
This example shows how to display all trust-points.
Switch# show crypto pki trustpoints
Trustpoint Name
Imported certificates:
CA
local certificate
local private key
Trustpoint Name
Imported certificates:
CA
local certificate
local private key
(Optional) Specifies the name of the trust-point to be displayed.
: TP1 (primary)
: tongken.ca
: webserver.crt
: webserver.prv
: TP2
: chunagtel.ca
: openflow.crt
: openflow.prv
1199