D-Link DXS-3600 Series Cli Reference Manual page 715

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
By default, the LACP timeout mode is short.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port interface configuration.
Example
This example shows how to configure the port LACP timeout to long mode on Ethernet interface 1/0/1.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lacp timeout long
Switch(config-if)#
60-4 lacp system-priority
This command is used to configure the system priority. Use the no form of the command to revert the
system priority back to the default value.
lacp system-priority PRIORITY
no lacp system-priority
Parameters
PRIORITY
Default
The default LACP system-priority is 32768.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
During LACP negotiation, the system priority and port priority of the local partner will be exchanged with
the remote partner. The switch will use port priority to determine whether a port is operating in a backup
mode or in an active mode. The LACP system-priority determines the switch that controls the port priority.
Port priorities on the other switch are ignored.
The lower value has a higher priority. If two switches have the same system priority, the LACP system ID
(MAC) determines the priority. The LACP system priority command applies to all LACP port-channels on
the switch.
Example
This example shows how to configure the LACP system priority to be 30000.
Switch# configure terminal
Specifies the system priority. The range is 1 to 65535.
710