D-Link DXS-3600 Series Cli Reference Manual page 848

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default EXP to CoS map:
•
CoS:
•
EXP:
Command Mode
MPLS QoS Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The EXP to CoS map is used to map an EXP value in the encapsulation of the label header to an internal
CoS value.
Example
This example shows how to configure the EXP to CoS map in MPLS QoS "policy1".
Switch# configure terminal
Switch(config)# mpls qos policy policy1
Switch(config-mpls-qos)# class map exp-cos 0,2-7 to 3
Switch(config-mpls-qos)# class map exp-cos 1 to 6
Switch(config-mpls-qos)#
71-4 clear mpls ldp neighbor
This command is used to clear LDP neighbor sessions.
clear mpls ldp neighbor {all | IP-ADDRESS}
Parameters
all
IP-ADDRESS
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to clear LDP neighbor sessions.
Example
This example shows how to clear all LDP neighbors.
Switch# clear mpls ldp neighbor all
Switch#
0 1 2 3
2 0 1 3
Specifies to clear all neighbors.
Specifies the IP address which is used as the peer LSR ID.
4 5 6
4 5 6
843
7
7