Safeguard Engine Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

95. Safeguard Engine Commands

95-1 clear cpu-protect counters
This command is used to clear the CPU protect related counters.
clear cpu-protect counters {all | sub-interface [manage | protocol | route] | type [PROTOCOL-
NAME]}
Parameters
all
sub-interface [manage |
protocol | route]
type [PROTOCOL-NAME]
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
If this command is issued without parameters, then all CPU protect related counters will be cleared.
Example
This example shows how to clear all CPU protect related statistics.
Switch# clear cpu-protect counters all
Switch#
95-2 cpu-protect safeguard
This command is used to enable or configure the Safeguard Engine. Use the no form of this command to
disable the Safeguard Engine
cpu-protect safeguard [threshold RISING-THRESHOLD FALLING-THRESHOLD]
no cpu-protect safeguard [threshold]
Parameters
threshold
Specifies to clear all CPU protect counters.
Specifies to clear the CPU protect related counters of sub-interfaces. If
no sub-interface is specified then the CPU protect related counters of
all sub-interfaces will be cleared.
Specifies to clear the CPU protect related counters of the specified
protocol. If no protocol name is specified, then all protocols will be
cleared.
(Optional) Specifies to configure the utilization to control when the
Safeguard Engine function will activate.
1176