Show Vrrp - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to configure the critical IP address of a virtual router. Use the no form of this
command to remove the critical IP address.
vrrp VRID track critical-ip IP-ADDRESS
no vrrp VRID track critical-ip
Parameters
VRID
IP-ADDRESS
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to set the critical IP address for one virtual router. If the critical IP is configured on
one virtual router, the virtual router cannot be activated when the critical IP address is unreachable. One
VRRP group can only track one critical IP.
Example
This example shows how to configure the critical IP address of virtual router 1 on VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# vrrp 1 track critical-ip 192.168.100.1
Switch(config-if)#
119-10

show vrrp

This command is used to display the VRRP settings and status.
show vrrp [interface INTERFACE-ID [VRID]]
Parameters
INTERFACE-ID
VRID
Default
None.
Command Mode
Specifies the virtual router identifier that identifies the VRRP group.
The valid range is from 1 to 255.
Specifies the critical IP address.
(Optional) Specifies the interface ID.
(Optional) Specifies the virtual router identifier that identifies the VRRP
group. The valid range is from 1 to 255.
1381