Virtual Private Lan Service (Vpls) Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
117. Virtual Private LAN Service (VPLS)
Commands
117-1 addition ac vlan
This command is used to configure the addition VLAN of the AC. Use the no command to delete the
addition VLAN.
addition ac vlan VLAN-ID
no addition ac vlan
Parameters
VLAN-ID
Default
By default, no addition VLAN exists on the AC.
Command Mode
Xconnect VFI Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the addition VLAN for the port-VLAN-based AC. The ingress packets
on the port with the addition VLAN ID can also be sent to the Pseudo-Wire (PW) as the packets ingress
on the AC.
Example
This example shows how to configure the addition VLAN of the AC:
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/1
Switch(config-if)# service encapsulation svid 100
Switch(config-if-srv)# xconnect vfi vpls200
Switch(config-if-xconn)# addition ac vlan 20
Switch(config-if-xconn)#
117-2 clear mac-address-table vpls
This command is used to clear the VPLS MAC address.
clear mac-address-table vpls dynamic {all | VPLS-NAME [peer IP-ADDRESS [VC-ID] | ac
INTERFACE-ID [vlan VLAN-ID] | address MAC-ADDR]}
Parameters
(Optional) Specifies the addition VLAN ID.
1350