D-Link DXS-3600 Series Cli Reference Manual page 620

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to display the IS-IS IP routing table.
Switch# show ip isis route
Codes: C - connected, E – external, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, D - discard, e - external metric
Area (null):
Destination
C 10.0.0.0/8
Switch#
Display Parameters
Codes
Area
Destination
Metric
Next Hop
Interface
48-36 show ipv6 isis route
This command is used to display the IS-IS IPv6 routing table information.
show ipv6 isis [AREA-TAG] route
Parameters
AREA-TAG
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Metric Next-Hop
0 --
The type of the route. It can be one of the following values:
C - The route is directly connected.
E - The route is imported from other routing domain.
L1 - The route is an area route.
L2 - The route is an inter-area route.
ia - The route is imported from a L2 route.
D - The route is discarded.
e - The route has an external metric.
The IS-IS instance area tag.
The IP address of a network.
The cost of reaching the destination.
The IP address of the next router to forward the packet.
The interface transmitting the forwarding packets.
(Optional) Specifies the tag of a routing process.
615
Interface
vlan1