D-Link DXS-3600 Series Cli Reference Manual page 972

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
76-20 router-id (IPv6)
This command is used to specify a router ID for the OSPF process. Use the no command to return to the
automatic router ID.
router-id ROUTER-ID
no router-id
Parameters
ROUTER-ID
Default
By default, an IP address is uniquely chosen as the router ID.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The router ID is a 32-bit number assigned to each router running OSPF. This number uniquely identifies
the router within an Autonomous System. Each router has a unique router ID among IPv6 OSPF
processes.
Example
This example shows how to specify a fixed router ID.
Switch# configure terminal
Switch(config)# ipv6 router ospf 1
Switch(config-rtr)# router-id 10.1.1.1
Switch(config-rtr)#
76-21 show ipv6 ospf
This command is used to display general information about OSPF routing processes.
show ipv6 ospf [PROCESS-ID]
Parameters
PROCESS-ID
Default
None.
Specifies the router ID in the IPv4 address format.
(Optional) Specifies the internally used identification parameter for an
IPv6 OSPF routing process. It is locally assigned and can be any
positive integer. A unique value is assigned for each IPv6 OSPF
routing process.
967