Subaru XT 1988 Service Manual page 195

ENGINE
2-3
L2-489
Fig.
86
4)
Install flywheel housing with housing cover and pitching
stopper bracket.
Tightening torque:
34 - 40 N·m (3.5 - 4.1 kg-m, 25 - 30 ft-Ib)
5)
Install flywheel to crankshaft using FLYWHEEL
STOPPER (498277000) for locking crankshaft. [Manual
transm ission model]
Tightening torque:
69 - 75 N·m (7.0 - 7.6 kg-m, 51 - 55 ft-Ib)
6)
Install drive plate and reinforcement using DRIVE PLATE
9) Install oil pump ASSY, proceeding as follows:
(1)
Thoroughly remove. excess fluid packing from rotor
housing of cylinder block.
(2)
Apply a small amount of fluid packing (Three·bond
1215, or equivalent) to the portion indicated by arrow in
figure in cylinder block.
(3)
Apply ample engine oil to rotor housing, then insert
outer rotor into rotor housing by setting it as shown.
(4)
Set oil pump pulley as shown, and install oil pump
ASSY to cylinder block with gasket placed between. After
installing, make sure pulley can be rotated smoothly.
Outer rotor direction
Pulley direction
L2·187
STOPPER (498497000) for locking crankshaft. [Automatic Fig.
87
transmission model]
Tightening torque:
69 - 75 N·m (7.0 - 7.6 kg-m, 51 - 55 ft-Ib)
7}
Position the clutch cover so that the
"e"
marks on the
flywheel and clutch cover are spaced 120
0
or more.
Install clutch disc and clutch cover with bolts and spring
washers, aligning clutch disc with flywheel by inserting
CLUTCH DISC GUIDE (499747000) into needle bearing
fitted in flywheel. [Manual transmission model]
Tightening torque:
16 N·m (1.6 kg-m, 12 ft-Ib)
8) Install seal to water pump, then install the water pump
and timing plate to cylinder block with gasket placed between.
39
(5)
Install oil pressure switch or oil pressure gauge to oil
pump ASSY. Loosen oil pressure gauge lead clamping
screw and route the lead on the side of #1 and #3
cylinders.
Tightening torque:
22 - 27 N·m (2.7 - 2.8 kg-m, 16 - 20 ft-Ib)
10) Insert valve lash adjusters into cylinder head.
Be sure to insert each valve lash adjuster to its original
position.
11) Apply grease to spherical surface and sl iding surface of
each valve rocker, then secure valve rockers to the respective
valve adjusters and valves.