Subaru XT 1988 Service Manual page 250

1...
2-3 ENGINE
3) Install flywheel to crankshaft using FLYWHEEL
STOPPER (498277000) for locking crankshaft. [Manual
transm iss ion model)
Tightening torque:
69 - 75 N'm (7.0 - 7.6 kg-m, 51 - 55 ft-Ib)
4) Install drive plate and reinforcement using DRIVE PLATE
STOPPER (498497000) for locking crankshaft. [Automatic
transmission model)
Tightening torque:
69 - 75 N'm (7.0 - 7.6 kg-m, 51 - 55 ft-Ib)
5) Position the clutch cover so that the "e" marks on the
flywheel and clutch cover are spaced 120
0
or more.
Install clutch disc and clutch cover with bolts and spring
washers, aligning clutch disc with flywheel by inserting
CLUTCH DISC GUIDE (499747000) into needle bearing
fitted in flywheel. [Manual transmission model)
Tightening torque:
14.2 - 17.2 N'm
(1.45 - 1.75 kg-m, 10.5 - 12.7 ft-Ib)
6)
Install seal to water pump, then install the water pump
to cylinder block with gasket placed between.
7) Install oil pump ASSY, proceeding as follows:
(1) Thoroughly remove. excess fluid packing from rotor
housing of cylinder block.
(2) Apply a small amount of fluid packing (Three-bond
1207B or equivalent) to the portion indicated by arrow in
figure in cylinder block.
Remove any Three Bond 1207B which protrudes into rotor
chamber.
(3) Apply ample engine oil to rotor housing, then insert
outer rotor into rotor housing by setting it as shown.
(4) Set oil pump pulley as shown, and install oil pump
ASSY to cylinder block with gasket placed between. After
installing, make sure pulley can be rotated smoothly.
Apply grease to oil pump gasket to prevent dislocation fro-m
the groove.
94
Rotor housing
Outer rotor direction
Pulley direction
L2-187
Fig. 227
8) Insert valve lash adjusters into cylinder head.
Be sure to insert each valve lash adjuster to its original
position.
9) Apply grease to spherical surface and sliding surface of
each valve rocker, then secure valve rockers to the respective
valve adjusters and valves.
Be sure to apply grease; otherwise, valve rocker will drop off.
10) Apply fluid packing (Three-bond 1207B or equivalent) to
groove of each camshaft case, then install to cylinder head.
Tightening torque:
23 - 26 N-m (2.3 - 2.7 kg-m, 17 - 20 ft-Ib)
After installing, abundantly apply engine oil to sliding surfaces
of cam and valve rocker.
11) Attach gaskets to valve rocker covers, and install the
covers to camshaft cases with rocker cover washers and bolts.
Tightening torque:
4.4 - 5.4 N·m (0.45 - 0.55 kg-m, 3.3 - 4.0 ft-Ib)
12) Install timing belt, belt cover and related parts. (Refer to
"Timing Belt and Belt Cover".)