Subaru XT 1988 Service Manual page 244

2-3
ENGINE
3) Rotate crankshaft to bring #1 and
#2
pistons to BDC
position.
To turn crankshaft, turn crankshaft pulley bolt and not the
crankshaft pulley.
4) Remove piston circlip through service hole of #1 and
#2
cylinders.
j
Fig. 202
Long nose
pliers
L2-1357
5) Draw out piston pin from #1 and
#2
pistons using
PISTON PIN REMOVER.
~PISTON
PIN REMOVER
~
(499097300)
Fib. 203
L2-1358
6) Turn crankshaft and remove
#5
&
#f3
and
#3
&
#4
in a
manner similar to removal of #1 and
#2.
7) Remove all cylinder block connecting bolts except one
Fig. 204
8) Set up cylinder block so that #1,
#3
and
#5
cylinders are
on the upper side, then separate left-hand and right-hand
cylinder blocks.
When separating cylinder block, do not allow the connecting
rod to fall and damage the cylinder brock.
L2-1360
Fig. 205
9) Remove coolant passage G-ring and back-up ring from
cylinder block.
L2-1361
bolt of
#3
cylinder.
Fig. 206
88