Subaru XT 1988 Service Manual page 196

2-3
ENGINE
Be sure to apply grease; otherwise, valve rocker will drop off.
Valve rocker
L2-490
Fig. 88
12) Install O-ring to camshaft case by setting camshaft so that
camshaft straight pin is oriented as shown.
L2-491
Fig. 89
13) Apply fluid packing (Three-bond 1215, or equivalent) to
groove of each camshaft case, then install to cylinder head.
After installing, abundantly apply engine oil to sliding surfaces
of cam and valve rocker.
Tightening torque:
17.2 - 20.1 N-m (1.75 - 2.05 kg-m, 12.7 - 14.8 ft-Ib)
HIREEBOND 1215
Fig. 90
. .
.
0.5 - 1 mm (0.020 - 0.039 in)
L2-191
40
14) Attach gaskets to valve rocker covers, and install the
covers to camshaft cases with rocker cover washers and bo Its.
Be extremely careful not to cause oil to leak from mating faces
of valve rocker cover and camshaft case.
Tightening torque:
4.4 - 5.4 N·m (0.45 - 0.55 kg-m, 3.3 - 4.0 ft-Ib)
15} Install timing belt, belt cover and related parts. (Refer to
"Timing Belt and Belt Cover".)
16) Install crank pulley to crankshaft using FLYWHEEL
STOPPER (498277000) [manual transmission model) or
DRIVE PLATE STOPPER (498497000) [automatic transmis-
sion model) to lock crankshaft.
Tightening torque:
89 - 107 N·m (9.1 - 10.9 kg-m, 66 - 79 ft·lb)
17) Install water pump pulley and pulley cover to water pump
ASSY, and tighten bolts temporarily.
18} Install oil level gauge and gauge guide. Apply engine oil to
O-ri ng beforehand.
19) Install oil filler duct and bracket.
20) I nstall water by-pass pipe, hose, and water pipe_ Apply
coolant to O·rings beforehand.
21) Install air bleed hose_
22} Install alternator bracket, proceeding as follows. [All
except air conditioner model]
(1) Assemble bracket
®
and bracket @ temporarily
. with bolt
©
so that these two parts contact each other.
(2) Install assembled brackets
®
and
@
to engine, and
hand-tighten bolts
(E)
and
@.
(3) Tighten bolt
@
to the specified torque, then tighten
bolt
(E)
to the specified torque.
(4) Tighten bolt
©
to the specified torque.
Tightening torque:
Bolt
©
16 - 22 N·m (1.6 - 2.2 kg-m, 12 - 16 ft-Ib)
Bolts
@
and
®
36 - 42 N'm (3.7 - 4.3 kg-m, 27 - 31 ft-Ib)