Subaru XT 1988 Service Manual page 230

2-3 ENGINE
6) I nstall crankshaft sprocket No.2 to crankshaft.
Sprocket No.2 can be identified by the absence of dowel pin.
7) Install timing belt LH.
(1) Align the center of three lines scribed on flywheel
with timing mark on flywheel housing.
Fig. 149
(2) Align timing mark on camshaft sprocket LH with
notch in belt cover.
Fig. 150
(3) Install timing belt from the crankshaft side. Be care·
fu I not to loosen it.
(4) I nstall left tensioner. Check that it moves smoothly
after installation.
Tightening torque:
39 - 47 N·m (4.0 - 4.8 kg-m, 29 - 35 ft-Ib)
L2·1317
Fig. 152
(5) Remove BELT ADJUSTER SroPPER from belt-ten-
sion adjuster.
Fig. 153
a. Check that the end of left tensioner arm
conta~ts
top of belt tension adjuster.
b. Make sure that flywheel timing mark and camshaft
sprocket LH timing mark are in their normal posi·
tions.
8) Install timing belt RH.
(1) Turn crankshaft one turn clockwise from the position
where timing belt LH was installed and align the center of
three lines scribed on the flywheel with timing mark on
flywheel housing.
(2) Align timing mark on camshaft sprocket RH with the
Fig. 151 notch in belt cover.
74