Camshaft And Valve Rocker - Subaru XT 1988 Service Manual

2-3
ENGINE
(16) Apply the specified torque (same as camshaft
sprocket LH) to camshaft sprocket RH in counterclock-
wise direction using BELT TENSION WRENCH. While
applying torque, tighten tensioner No.2 bolt
@
tem·
porarily, then tighten bolt
®
temporarily.
Fig. 31
(17) Tighten bolt
@
and bolt
®,
in that order, to the
specified torque.
Tightening torque:
17.2 - 20.1 N·m (1.75 - 2.05 kg·m, 12.7 - 14.8 ft·lb)
(18) Make sure that flywheel timing mark and camshaft
sprocket RH timing mark are in their normal positions.
(19) Remove crankshaft pulley.
Do not remove sprocket with crankshaft pulley.
10) Install belt cover FR seal, belt cover RR seal, and belt
cover plug to belt cover FR. then install belt cover FR to
cylinder block.
Before installing belt cover, ensure that no foreign matter such
as nut or washer is in it.
Fig. 32
22
11) Install belt covers LH and RH.
12) Insert crank pulley to crankshaft using FLYWHEEL
STOPPER (498277000) [manual transmission modelJ or
DR IVE PLATE STOPPE R (498497000) [automatic transmis·
sion model) to lock crankshaft.
Tightening torque:
89 - 107 N· m (9.1 - 10.9 kg·m, 66 - 79 ft·lb)
13) Install water pump pulley and pulley cover to water pump
ASSY. and tighten nuts temporarily.
14) Install oil level gauge and gauge guide. Apply engine oil to
O·ring beforehand.
15) Connect lead to oil pressure switch.
16)
Inst~11
V·belt and apply proper tension to the belt.
17) Tighten water pump pulley mounting nuts or bolts to the
specified torque.
Tightening torque:
9.1 -10.5 N·m (0.93 -1.07 kg·m, 6.7 -7.7 ft·lb)
Camshaft and Valve Rocker
REMOVAL
1) Removing distributor
(1) Disconnect spark plug cords from distributor.
(2) Remove distributor by removing mounting bolts.
2) Remove timing belt. belt cover and related parts. (Refer
to "Timing Belt and Belt Cover".)
3) Remove water pipe.
4) Remove oil filler duct.
5) Remove PCV hoses from rocker cover.