Crankshaft And Piston - Subaru XT 1988 Service Manual

ENGINE
2-3
Fig. 91
23) Install power steering oil pump bracket to cylinder block.
[Power steering model]
24) Install harnesses.
25) Install hoses and tubes.
26) Install alternator to bracket, and tighten bolts temporarily.
[Except air conditioner model]
27) Install distributor, proceeding as follows:
(1) Bring #1 cylinder piston to its top dead center on
compression stroke. Set camshaft sprocket to the position
shown in Figure.
Camshaft sprocket position
Flywheel position
L2-1058
Fig. 92
(2) Align distributor housing match mark with pinion
Fig.
93
(3) Install distributor to camshaft case.
(4) Connect lead wires.
(5) Install plug cord and high-tension cord.
28) I nstall right and left belt covers.
29) Remove ENGINE STAND (499817100).
30) Install air duct and boots.
L6-080
After completing engine ASSY and mounting engine on car, be
sure to retighten cylinder head bolts.
(Refer to "2·2 ON·CAR SERVICES".)
Crankshaft and Piston
DISASSEMBLY
PISTON
1) Remove the piston rings using the piston ring expander.
L2-813
gear match mark to set #1 cylinder at igniting position. Fig. 94
41