Subaru XT 1988 Service Manual page 227

ENGINE 2-3
(4) I nsert a standard screwdriver into the hole in the bot·
tom of belt tension adjuster. Turn the screw clockwise to
loosen belt tension and install BE L T ADJUSTE R STOP·
PER (13082AAOOOl. Remove the left belt tensioner.
Fig. 135
(5) Remove timing belt after marking rotating direction
of belt.
Fig. 136
13) Remove crankshaft sprocket No.2 and idler pulley.
14) Remove belt tension adjuster.
Oc
o~
Oc
Fig. 137
71
After removing belt tension adjuster, reinstall plug screw in the
bottom.
15} Remove camshaft sprocket R Hand LH.
L2·1305
Fig. 138
16) Remove belt cover No.2 R Hand LH.
Belt cover No.2 (LH)
L2-1306
Fig. 139
INSPECTION
TIMING BELT
1} Check timing belt teeth for breaks, cracks, and wear.
If any fault is found, replace belt.
2} Check the condition of back side of belt; if any crack is
found, replace belt.
a. Be careful not to let oil, grease or coolant contact the beit.
Remove quickly and thoroughly if this happens.
b. Do not bend the belt sharply.