Subaru XT 1988 Service Manual page 229

ENGINE
(2) I nsert a standard screwdriver into the hole in the bot-
tom of belt tension adjuster. Turn the screw clockwise to
compress rubber boot. Then install BELT ADJUSTER
STOPPER (13082AAOOOO).
The clip furnished as a spare part can be used in place of BELT
ADJUSTER STOPPER.
BELT ADJUSTER
STOPPER
L2-1310
Fig. 144
(3) Using a syringe, add engine oil through air vent hole
on top of rubber boot until it overflows.
L2-1311
Fig. 145
(4) Install plug screw.
Be sure to use a new plug screw gasket.
(5) I nstall belt tension adjuster.
Tightening torque:
23 - 26 N·m (2.3 - 2.7 kg·m, 17 - 20 ft-Ib)
Fig. 146
4) Install plug rubber.
Fig_ 147
5) Install idler pulley.
Tightening torque:
39 - 47 N·m (4.0 - 4.8 kg-m, 29 - 35 ft-Ib)
Fig_ 148
73
2-3
L2-1312
L2-1313