Subaru XT 1988 Service Manual page 237

I
ENGINE
2-3
Timing mark
L2-1338
Fig. 174
(2)· Align distributor housing match mark with pInion
gear match mark to set #1 cYlinder at igniting position.
Fig. 175
Matching
mark
(3) Install distributor to camshaft case.
(4) Connect lead wires.
(5) Install plug cord and high-tension cord.
11) Install right and left belt covers.
Cylinder Head
REMOVAL
1) Remove timing belt, belt cover and related parts.
(Refer to "Timing Belt and Belt Cover"')
L2-1339
2) Remove camshaft cases, lash adjuster and related parts.
(Refer to "Camshaft and Valve Rocker".)
3) Remove alternator.
4) Remove compressor (A/C).
5) Remove bolts attaching intake manifold to cylinder head,
L2-1340
Fig. 176
6) Remove water by-pass pipe to cylinder head.
7) Remove alternator bracket to cylinder head.
L2-1341
Fig. 177
8) Remove spark plugs.
9) Remove cylinder heads from cylinder block.
Loosen cylinder head bolts in two or three steps, in the order
shown in figure below, and remove them.
L2-1342
and then lift intake manifold from cylinder head.
Fig. 178
8 1 r