Cooling Fan And Fan Motor - Subaru XT 1988 Service Manual

ENGINE COOLING SYSTEM 2-5
4) Install sub and main fan shroud on radiator (2700 cc
Cooling Fan and Fan Motor
model only).
Tightening torque:
Lower and upper bolt
7.3-7.7 N·m
(0.74 - 0.79 kg-m, 5.4 - 5.7 ft-Ib)
5) Connect main harness connector to thermoswitch.
6} Connect lead wire connector to fan motor.
7) Connect both inlet and outlet hoses to radiator with
marked sides facing up and tighten with hose clamps.
Be careful not to twist hoses.
8) Connect both inlet and outlet hoses to radiator's oil
cooler and tighten with hose clamps (A/T model).
9) Pour coolant into radiator.
10) Connect ground cable to battery term inal.
15
REMOVAL
1) Disconnect ground cable from battery terminal.
2) Disconnect lead wire connector.
3) Remove bolts holding shroud to radiator and detach
shroud.
-
Fig. 23
4) Remove fan motor mounting nuts and detach fan motor
from shroud.
Do not separate fan motor and fan as they are balanced
properly.
INSTALLATION
Installation is in the reverse order of removal procedures.
Observe the following:
1) Before installing cooling fan motor, apply a coat sealant
to threads and tighten nuts.
Tightening torque:
Fan motor to shroud
7.3 -7.7 N·m
(0.74 - 0.79 kg-m, 5.4 - 5.7 ft-Ib)
2) Make sure cooling fan does not come into contact with
shroud when installed.
3) After installation, make sure there is no unusual noise or
vibration when fan is rotated.