Subaru XT 1988 Service Manual page 182

2-3
ENGINE
3) Install D-ring to camshaft case by setting camshaft so that
camshaft straight pin is oriented as shown.
Straight pin
L2-807
Fig.
42
4) Apply fluid packing (Three-bond 1215, or equivalent) to
groove of each camshaft case, then install to cylinder head.
After installing, abundantly apply engine oil to sliding surfaces
of cam and valve rocker.
Tightening torque:
17.2 - 20.1
N·m
(1.75 - 2.05
kg-m,
12.7 - 14.8
ft-Ib)
THREEBOND 1215
0.5 - 1 mm (0.020 - 0.039 in)
L2-191
Fig. 43
5) Attach gaskets to valve rocker covers, and install the
covers to camshaft cases with rocker cover washers and bolts.
Be extremely careful not to cause oil to leak from mating faces
of valve rocker cover and camshaft case_
Tightening torque:
4.4 - 5.4
N·m
(0.45 - 0.55
kg-m,
3.3 - 4.0
ft-Ib)
::." 26
.~
6) Install PCV hoses.
7) Install oil filler duct.
8) Install water pipe.
9) Install timing belt, belt cover and related parts. (Refer to
"Timing Belt and Belt Cover".)
10) Install distributor, proceeding as follows:
(1) Bring
#1
cylinder piston to its top dead center on
compression stroke. Set camshaft sprocket to the position
shown in Figure.
Camshaft sprocket position
Flywheel position
Timing mark
L2-1058
Fig.
44
(2) Align distributor housing match mark with pinion
gear match mark to set
#1
cylinder at igniting position.
Fig. 45
(3) Install distributor to camshaft case.
(4)
Connect lead wires_
(5) Install plug cord and high-tension cord.
11) Install right and left belt covers.
L6-080