Subaru XT 1988 Service Manual page 248

2-3
ENGINE
8) Install pistons in cylinder as follows:
(1) Apply oil to the circumference of piston and the
inner surface of cylinder.
(2) With the
#5
and
#6
cyl inders facing downwards, turn
crankshaft until the
#3
and
#4
connecting rod comes to
the bottom dead center. Then insert the
#4
piston into
cylinder by using PISTON GUIDE (398744300).
Fig. 219
(3) Install piston pin through the service hole after align-
ing the service hole, piston pin hole, and connecting rod
small end with PISTON PIN GU IDE (499017000).
Fig. 220
(4) Install circlips through the service hole, using long-
nosed pliers.
Circlip must be installed in correct direction with its end
facing out.
92
~ =~~:~~~s
end
i::'
Long nose pliers
L2-1376
Fig. 221
(5) Circlips must be installed in the order of #3, #1,
#2,
#5
and
#6
pistons.
(6) Turn crankshaft, and check whether piston and cir-
cI ip are assembled correctly.
9) Apply fluid packing (Three-bond 1205 or equivalent) to
plugs, and tighten it with aluminium gasket placed in between.
Tightening torque:
62 -76 N·m (6.3 -7.7 kg-m, 46 - 56 ft-Ib)
Fig. 222
10) Install front oil seal to cylinder block using INSTALLER
(499567100).
Coat the outside surface of oil seal with engine oil and oil seal
lip with grease. Force·fit oil seal squarely into position.