Subaru XT 1988 Service Manual page 249

ENGINE
2-3
Fig. 223
111 Install rear oil seal to cylinder block using INSTALLER
(499587000) .
Coat the outside surface of oil seal with engine oil, and oil seal
lip with grease. Force-fit oil seal squarely into position.
INSTALLER
Fig. 224
12) Install oil separator cover with gasket placed in be-
tween.
Tightening torque:
4.4 - 5.4 N·m (0.45 - 0.55 kg-m, 3.3 - 4.0 ft-Ib)
13) Install flywheel housing.
Tightening torque:
34 - 40 N·m (3.5 - 4.1 kg-m, 25 - 30 ft-Ib)
93
Fig. 225
INSTALLATION
1 )
Install oil pan.
Tightening torque:
4.4 - 5.4 N·m (0.45 - 0.55 kg-m, 3.3 - 4.0 ft-Ib)
2) Install cylinder heads to cylinder blocks with gaskets
placed between.
When tightening bolts, apply oil to the threads and tighten
them in two successive steps until the final tightening is at the
specified torque.
(Refer to "Cylinder Head".)
L2-1348
Fig. 226
Tightening torque:
60 - 68 N·m (6.1 - 6.9 kg-m, 44 - 50 ft·lb)