Subaru XT 1988 Service Manual page 232

L - __
2-3 ENG1NE
9) Install belt cover CTR.
Fig. 158
10)
Install crankshaft pulley to crankshaft using FLYWHEEL
STOPPER (498277000) [manual transmission model] or
DRIVE PLATE STOPPER (498497000) [automatic transmis-
sion model] to lock crankshaft.
When tightening bolt, apply engine oil to the threads, then
tighten.
Tightening torque:
89 - 107
N·m
(9.1 - 10.9 kg-m. 66 - 79
ft-Ib)
, 'I
11) Install oil level gauge guide.
Tightening torque:
4.4 - 5.4 N·m (0.45 - 0.55 kg-m, 3.3 - 4.0 ft-Ib)
12) Install water pipe. Apply coolant to O-ring beforehand.
13) Install water pump pulley to water pump ASSY, and
tighten nuts temporarily.
14) Install belt covers RH and LH.
15) Install compressor (A/C).
16) Install alternator.
Fig. 159
17) Install V-belt and apply proper tension to the belt.
(1) Loosen belt tension pulley lock nut.
(2)
Turn adjusting bolt to adjust belt tension.
The belt tightens when the bolt is turned clockwise and
vice versa.
Fig. 160
~
H: mm On)/
Tension:
98 N (10 kg, 22 Ib) N (kg,lb)
New belt 5.5 - 6,5 (0.217 - 0.256)
637 -736
(65 - 75, 143 - 165)
Existing belt 6.5 - 7,5 (0.256 - 0.295)
441 - 637
(45 - 65,99 - 143)
(3) Tightel?-Iock nut.
Tightening torqOe:
34 - 44 N·m (3.5 - 4.5 kg-m, 25 - 33 ft-Ib)
(4) After adjusting belt tension, turn adjusting bolt coun-
terclockwise to lock.
Tightening torque:
4 - 6 N·m (0.4 - 0.6 kg-m, 2.9 - 4.3 ft-Ib)
When replacing belt with a new one, adjust its tension to the
specification, then readjust it to the same specification after
running engine for 5 minutes in consideration of its initial ex-
pansion.
18) Tighten water pump pulley mounting bolts.
76