Agilent Technologies E5071C Manual page 1194

Hide thumbs Also See for E5071C:

Table of Contents

Puts the instrument into preset state.

Allocates the windows to the upper left, upper right, lower left, and lower

Lines 740 to 1020

Repeat the following for channels 1 to 4, where Ch is the channel number.

Lines 780 to 810: For the E5091A whose ID is 1, set the port assigned to

port 1 to Port1(Ch-1), the port assigned to port 2 to Port2(Ch-1), the Port

assigned to port 3 to Port3(Ch-1), and the port assigned to port 4 to

Port4(Ch-1).

Line 820: Sets the control line of the E5091A whose ID is 1 to Clines(Ch-

Lines 860 to 890: Set the sweep start value to Freq_star(Ch-1), the

sweep stop value to Freq_stop(Ch-1), the number of points to Nop(Ch-1),

and the number of traces to N_tr(Ch-1).

Lines 910 to 950: If the fixture simulator function is ON (Fsim(Ch-1) is

True), these lines set the fixture simulator function to ON, the device type

to Dev(Ch-1), the port assignment to Tpl(Ch-1), the balance-unbalance

conversion to ON, and the measurement parameter (mix mode S-

parameter) to Trc(Ch-1).

Line 970: If the fixture simulator function is OFF (Fsim(i) is False), sets

the measurement parameter (S-parameter) to Trc(Ch-1).

Lines 990 to 1010: Set the title label to Ttl(Ch-1), the title display to ON,

and the continuous startup mode to ON.

Sets the trigger source to "Bus."

Lines 1050 to 1060

For the E5091A whose ID is 1, set the property display to ON and the

control to ON.

Lines 1100 to 1120

Recall the Function procedure: ECal_solt (Lines 1410 to 1770) to execute

the calibration of channel 1 with the ECal module (full 2-port calibration of

E/span> E/span>

Show Quick Links

Table of Contents