Agilent Technologies E5071C Manual page 1204

sweep stop value to the Stop_p variable, and the fixed frequency to the
Cw_freq variable.
Lines 340 to 370
Display a message asking whether to execute the zero adjustment and
calibration of the power sensor. If the Yes button is clicked, these lines call
the procedure: Control_PowerMeter (Line 900 to Line 1340). On the other
hand, if the No button is clicked, the program skips the zero adjustment
and calibration of the power sensor.
Lines 410 to 420
Clear the error queue. Then, these lines prompt you to connect the power
sensor to port 1 of the E5071C and wait for the OK button to be clicked
after the connection.
Lines 450 to 470
For port 1 of channel 1, these lines set the number of power calibration
data measurements for each measurement point to the Num_avg variable
and then start the measurement of the power calibration data and wait for
the completion of the measurement.
Line 500
Reads out an error that has occurred in the E5071C during the
measurement of the power calibration data and sets it in the Err variable.
Lines 510 to 590
If no error has occurred, these lines read out the power calibration data
array and set it in the Corr_data variable. In addition, the program uses
the Limit_Test function to check whether the read out power calibration
data array exceeds the specified limit value. If the limit value is exceeded,
the return value of the Limit_Test function, False, is returned. Then, a
message is displayed asking whether to perform the power calibration
again. Click the Yes button to return to the start of the power calibration
data measurement. Click the No button to terminate the program.
Lines 610 to 660
If an error occurs, display an error message and a message asking
whether to execute the power calibration again. Click the Yes button to
return to the start of the power calibration data measurement. Click the No
button to terminate the program.
Programming
1431