Device Range That Can Be Set - Mitsubishi Electric GT14 User Manual

Hide thumbs Also See for GT14:
Table of Contents

Advertisement

32.6 Device Range that Can Be Set

For details on the device range of controllers that can be
used on GT14 Handy, refer to the following manuals.
GT Designer3 Version1 Screen Design Manual
(Fundamentals)
GOT1000 Series Connection Manual (Non-
Mitsubishi Products 1) for GT Works3
32.7 Precautions
Program control device
• When Program Execution Command (0), Program
Exit Command (2), or Program Restart Command (4)
is written to the program control device (PRG 0), it
will be a request for all programs running in the
controllers.
• When unsupported write data is input to the program
control device, the following error is displayed in the
system alarm.
315: Device writing error.
Correct device.
Variable devices
The variable number 99 of Integer device and variable
number 199 of Real device are special devices used for
operations by the X-SEL controller system. Do not use
these variables for general purpose.
Command trigger compatible device
• For the device whose obtained data No.0 is a
command trigger, communication with the controller is
performed when the Write(1)/Read(2) is set to the
command trigger.
When the command trigger and setting value are
written in a batch, the communication is performed
based on the value set with batch write.
• When Clear(4) is set to the command trigger, the
communication with the controller is not performed
and the set value is initialized.
• When an unsupported set value is input to the
command trigger, the following error is displayed in
the system alarm.
315: Device writing error.
Correct device.
Device reserved for system use
Devices of ''Reserved for system uses'' are devices
with indefinite values. Do not write to this device.
32 - 28
32. CONNECTION TO IAI ROBOT CONTROLLER
32.6 Device Range that Can Be Set
Write to the flash ROM
• The point data can be written to the flash ROM of the
X-SEL controller. When the point data is written to the
flash ROM, it is not cleared even when power supply
to the controller is turned off. However, there are limits
in the number of writing. For details, refer to the user's
manual of X-SEL controller used.
• Never turn off the main power supply during the flash
ROM write. Doing so may cause the loss of data and
malfunction of controllers. For details, refer to the
user's manual of X-SEL controller used.
Communication disconnection
• Writing to the flash ROM disconnects the communication
with controllers until the writing is completed.
• Resetting software restarts the controllers. During this
time, the communication with controllers is
disconnected.
Connection of the IAI X-SEL K type
Note the following precaution when using the controller
with the mode switch set to MANU.
• After powering up the X-SEL, connecting the GOT
before the PC software causes the program startup
disabled (A1D alarm) on the X-SEL side.

Advertisement

Table of Contents
loading

Table of Contents