Precautions - Mitsubishi Electric GT14 User Manual

POINT POINT POINT
Channel No., drivers
(1) Channel No.2 to No.4
Use the channel No.2 to No.4 when using the Multi-channel function.
For details of the Multi-channel function, refer to the following.
(2) Drivers
The displayed items for a driver differ according to the settings [Manufacturer], [Controller Type] and [I/F].
When the driver to be set is not displayed, confirm if [Manufacturer], [Controller Type] and [I/F] are correct.

18.1.3 Precautions

(1) When using the multiple CPU system
When using the GOT to monitor the multiple CPU system of other stations, select [MELSEC-Q(Multi)/Q-Motion]
or [MELSEC-QnU/DC, Q17nD/M/NC/DR, CRnD-700] for the type, regardless of the host PLC CPU type (QCPU,
QnACPU, ACPU).
When other models are selected, the setting of the CPU No. becomes unavailable.
(2) Precautions for changing model
(a) When devices that cannot be converted are included.
When setting of [Manufacturer] or [Controller Type] is changed, GT Designer3 displays the device that
cannot be converted (no corresponding device type, or excessive setting ranges) as [??]. In this case, set
the device again.
(b) When the changed Manufacturer or Controller Type does not correspond to the network.
The network will be set to the host station.
(c) When the Manufacturer or Controller Type is changed to [None]
The GT Designer3 displays the device of the changed channel No. as [??]. In this case, set the device
again.
Since the channel No. is retained, the objects can be reused in other channel No. in a batch by using the
[Device Bach Edit], [CH No. Batch Edit] or [Device List].
18.2 Common Settings Dedicated to Handy GOT
The following data are written as common settings: the system information to control the LED display for the Handy GOT
operation switch and for the grip switch.
After defining the system information and the Handy GOT setting in [Common Settings] of drawing software, write the
common settings to the Handy GOT.
For details on Common Settings, refer to the following manual.
For the settings on the display LED for grip switch, refer to the following section.
18 - 14
18. DRAWING SOFTWARE SETTINGS (CONTROLLER SETTING AND COMMON SETTINGS)
18.2 Common Settings Dedicated to Handy GOT
30. MULTI-CHANNEL FUNCTION
[Setting the communication interface] section in each chapter
GT Designer3 Version1 Screen Design Manual (Fundamentals)
9.4.8 LED settings of grip switch