Mitsubishi Electric GT14 User Manual page 654

Item Description
IP Label Set the IP label of the detail settings.
Set the subnet mask for the sub network.
(Only for connection via router)
Subnet
If the sub network is not used, the
Mask
default value is set.
(Default: 255.255.255.0)
Set the router address of the default
Default gateway where the GOT is connected.
Gateway (Only for connection via router)
(Default: 0.0.0.0)
Ethernet
Set the GOT port No. for Ethernet
Download
download. (Default: 5014)
Port No.
OK
Click the button when settings are completed.
POINT POINT POINT
(1) Setting the FA transparent function of GX Works2
When connecting the GOT and the personal
computer in Ethernet connection, set the GOT IP
address and the Ethernet download port No. to the
same as the contents of PLC side I/F detailed
setting of GOT.
31.6.4 Accessing by GX Works2
(2) Communication interface setting by Utility
The communication interface setting can be
changed on the Utility's [Communication Settings]
after downloading [Communication Settings] of
project data. For details on the Utility, refer to the
following manual.
11. COMMUNICATION INTERFACE SETTING
(COMMUNICATION SETTING)
(3) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
31 - 18
31. FA TRANSPARENT FUNCTION
31.5 GOT Side Settings
Range

GOT Setup
-
When using the multi-channel function, specify the channel
No. on which the FA transparent function is executed.
0.0.0.0 to
255.255.255.255
0.0.0.0 to
255.255.255.255
1024 to 5010,
5014 to 65534
(Except for 5011,
5012, 5013, and
49153)
1.
2.
3.
4.
Click the
POINT POINT POINT
2.
Select [Common] [GOT Environmental Setting]
[GOT Setup] from the menu.
Check [Enable GOT Setup].
Select the [Transparent] tab.
As necessary, check [CH1] or [CH2]. (Default: CH1)
OK
button when settings are completed.
Transparent setting on the utility screen
Transparent setting can be performed by the GOT.
For details of the operating, refer to the following.
12.3 Transparent Mode Setting
3. 4.
Click!