Mitsubishi Electric GT14 User Manual page 328

Hide thumbs Also See for GT14:
Table of Contents

Advertisement

(2) When installing with USB memory
Now installing BootOS.
Reboot.
POINT
POINT
POINT
(1) Drives to be used
When installing OS at power-on, use the A or E drive.
(2) Installation by pressing upper left corner of the GOT screen
When the OS boot drive is set to the A or E drive, installation by pressing upper left corner of the GOT screen
is not available.
17 - 6
17. INSTALLATION OF COREOS, BOOTOS AND STANDARD MONITOR OS
17.3 BootOS and Standard Monitor OS Installation Using SD card or USB Memory
1.
Power off the GOT, and install the USB memory
where the BootOS, standard monitor OS or project
data is stored in the USB interface of the GOT.
The BootOS cannot be stored in the USB memory
where the standard monitor OS or project data is
stored.
2.
Power on the GOT while pressing upper left corner
of the GOT screen. (1-point press installation
function)
3.
The BootOS or standard monitor OS is installed in
the built-in flash memory.
Do not pull out the USB memory or power off the
GOT while install execution.
4.
The GOT restarts automatically after the installation
is completed.
(When the standard monitor OS is already installed,
the GOT restarts by touching the [OK] button.)
5.
After confirming normal restart, remove USB
memory from the USB interface of the GOT.
For removing methods of the USB memory, refer to
the following.
14.2.9 USB device status display

Advertisement

Table of Contents
loading

Table of Contents