Station Number Setting - Mitsubishi Electric GT14 User Manual

51.5.6 Station number setting

Set each station number so that no station number
overlaps.
The station number can be set without regard to the cable
connection order. There is no problem even if station
numbers are not consecutive.
Station Station
No.3 No.7
GOT
Examples of station number setting
(1) Direct specification
When setting the device, specify the station number of
the temperature controller of which data is to be
changed.
Specification range
1 to 99
(2) Indirect specification
When setting the device, indirectly specify the station
number of the inverter of which data is to be changed
using the 16-bit GOT internal data register (GD10 to
GD25).
When specifying the station No. from 100 to 115 on GT
Designer3, the value of GD10 to GD25 compatible to
the station No. specification will be the station No. of
the temperature controller.
Specification Compatible
station NO. device
100 GD10
101 GD11
102 GD12
103 GD13
104 GD14
105 GD15
106 GD16
1 to 99
107 GD17
For the setting other than the above, an
error (dedicated device is out of range)
108 GD18
will occur.
109 GD19
110 GD20
111 GD21
112 GD22
113 GD23
114 GD24
115 GD25
Station Station Station
No.1 No.15 No.6
Setting range
51. CONNECTION TO YOKOGAWA TEMPERATURE CONTROLLER
(3) All station specification
Target station differs depending on write-in operation or
read-out operation.
• For write-in operation, all station will be a target. In the
WORD BIT write-in operation, only the temperature
controller whose station No. is the same as host
address is applicable.
51.4.2 Communication detail settings
• In the read-out operation, only the indicating controller
whose station No. is the same as host address is
applicable.
For details of host address setting, refer to the
following.
51.4.2 Communication detail settings
POINT POINT POINT
The all station specification can be set for the following
temperature controllers only.
UT420, UT450, UT520, UT550, UT551, UT750,
UP550, UP750,
US1000
51.5 Temperature Controller Side Setting
48
49
50
51
52
53
54
55
51 - 27