Mitsubishi Electric GT14 User Manual page 413

(3) MELSEC-WS
Item Description
Set this item when change the
transmission speed used for
communication with the connected
equipment. (Default: 115200bps)
Transmission
When the setting exceeds the limit of the
Speed
connected equipment, communication is
performed at the fastest transmission
speed supported by the connected
equipment
Set the number of retries to be performed
Retry when a communication error occurs.
(Default: 3times)
Set the time period for a communication
Timeout Time
to time out. (Default: 3sec)
Set this item to adjust the transmission
Delay Time timing of the communication request from
the GOT. (Default: 5ms)
POINT POINT POINT
(1) Communication interface setting by Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
11. COMMUNICATION INTERFACE SETTING
(COMMUNICATION SETTING)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
HINT HINT HINT
Cutting the portion of multiple connection of the
controller
By setting GOT internal device, GOT can cut the
portion of multiple connection of the controller. For
example, faulty station that has communication
timeout can be cut from the system.
For details of the setting contents of GOT internal
device, refer to the following manual.
GT Designer3 Version Screen Design
Manual (Fundamentals)
Range
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
0 to 5times
3 to 30sec
0 to 300
(ms)
Disconnect the
faulty station
21. DIRECT CONNECTION TO CPU
21.4 GOT Side Settings
17
18
19
20
21
22
23
24
21 - 31