Download Print this page
Mitsubishi Electric GT1020 Series Startup Manual

Mitsubishi Electric GT1020 Series Startup Manual

Graphic operation terminal, fx connection
Hide thumbs Also See for GT1020 Series:

Advertisement

Quick Links

GT1020/GT1030 to FX Connection
Note: This document is for reference only. For detailed settings and safety information refer to the respective product manual.
START- - - - UP GUIDE
START
START
START
UP GUIDE
UP GUIDE
UP GUIDE
1

Advertisement

loading

Summary of Contents for Mitsubishi Electric GT1020 Series

  • Page 1 START START START START- - - - UP GUIDE UP GUIDE UP GUIDE UP GUIDE GT1020/GT1030 to FX Connection Note: This document is for reference only. For detailed settings and safety information refer to the respective product manual.
  • Page 2 Ver. A GOT1000 Startup Guide GT1020/GT1030-to-FX Connection Overview: This document provides a simple guide and reference for setting up the GT1020 or GT1030 Graphic Operation Terminal (GOT) hardware and firmware for use with an FX Series PLC. Hardware Introduction: The GT1020 and GT1030 are monochrome, 3-color backlight, two communication channel GOT1000 Series touch panel interfaces, and consist of the following models: Model...
  • Page 3 through the communication cables, described below. 5V DC version GT1020 GOTs The GT1020-LBL and GT1020-LBLW are the only two 5V DC GOTs in the GOT1000 lineup. They are powered directly from the communication cable, and can only be connected with an FX Series PLC. Other PLCs and connectable products will not provide the necessary 5V DC power.
  • Page 4 * - Special Adapters require an additional FX**-CNV-BD or, for the FX3U only, a Communication Expansion Board. For all screw terminals on the GT1020/GT1030, use a small flathead screwdriver to secure the wires within the PLC Communication Connector (recommended blade size and tightening torque: 0.4 x 2.5 mm and 0.22 to 0.25 N•m).
  • Page 5 Note that using the GT10-RS2TUSB-5S will require a virtual USB COM port driver to be installed on the PC. The COM port number can be automatically or manually assigned so that it does not overlap with the existing COM port numbers assigned on that PC.
  • Page 6 To access the OS installation mode of the GT1020/GT1030, Power ON switch the GOT power from OFF to ON, while holding the bottom right corner of the touch screen (in Horizontal layout), illustrated to the right. While the “Please install the OS”...

This manual is also suitable for:

Gt1030 seriesGot1000 seriesGt1020Gt1030Gt1020-lbdGt1020-lbdw ... Show all