Mitsubishi Electric GT14 User Manual page 472


[Module parameter] of GX Works3
(1) Module parameter of Ethernet module (MELSEC iQ-
R Series)
Item
IP Address
Subnet Mask
Default Gateway
Setting Method of Network
No. and Station No.
*1
Network No.
*2
Station No.
Transient Transmission
Group No.
Online Program Change
Permission/Protection
Setting
Communication Data Code
Open Method Setting
Target Device Connection
Configuration Setting
: Necessary
*1 Set the same network No. as that of the GOT.
*2 Do not set the same station No. as that of the GOT.
23 - 22
23. ETHERNET CONNECTION
23.4 PLC Side Setting
Setting necessity at
Set value
GOT connection
192.168.3.19
-
-
Do Not Use IP
Address
1
2
(Use default value)
Refer to (2).
: As necessary : Not necessary
(2) Target Device Connection Configuration Setting
Item
Protocol
Open system
Host station port No.
POINT POINT POINT
When changing the module parameter
After writing module parameters to the PLC CPU, turn
the PLC CPU OFF then back ON again, or reset the
PLC CPU.
Set value
(Use default value)
MELSOFT connection (fixed)
(Use default value)