Mitsubishi Electric GT14 User Manual page 1040

Hide thumbs Also See for GT14:
Table of Contents

Advertisement

(2) HITACHI HIDIC H (Protocol2)
Item
Set this item when change the
transmission speed used for
Transmission
communication with the connected
Speed
equipment.
(Default: 19200bps)
Set this item when change the data length
used for communication with the connected
Data Bit
equipment.
(Default: 7bit)
Specify the stop bit length for
Stop Bit
communications.
(Default: 1bit)
Specify whether or not to perform a parity
check, and how it is performed during
Parity
communication.
(Default: Even)
Set the number of retries to be performed
Retry
when a communication error occurs.
(Default: 0time)
Set the time period for a communication to
Timeout Time
time out.
(Default: 3sec)
Set this item to adjust the transmission
timing of the communication request from
Delay Time
the GOT.
(Default: 0ms)
Specify whether to use the station No.
during communication.
Station No.
If [Yes] is selected, the station No. is fixed
Selection
to "0."
(Default: Yes)
POINT
POINT
POINT
(1) Communication interface setting by Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
11. COMMUNICATION INTERFACE SETTING
(COMMUNICATION SETTING)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
45 - 12
45. CONNECTION TO HITACHI IES PLC
45.4 GOT Side Settings
Description
Range
4800bps,
9600bps,
19200bps,
38400bps
7bit (fixed)
1bit (fixed)
Even (fixed)
0 to 5times
3 to 30sec
0 to 300 (ms)
Yes or No

Advertisement

Table of Contents
loading

Table of Contents