Table of Contents
Advertisement
[Module parameter] of GX Works3
(1) Built-in Ethernet port
(For MELSEC iQ-R Series)
Item
IP Address
Subnet Mask
Default Gateway
Online Program Change
Permission/Protection Setting
Communication Data Code
Open Method Setting
Target Device Connection
Configuration Setting
: Necessary
23 - 20
23. ETHERNET CONNECTION
23.4 PLC Side Setting
Setting
Set value
necessity at
GOT connection
192.168.0.1
-
-
(Use default value)
-
: As necessary
: Not necessary
[Controller Setting] and [Ethernet] of GT
Designer3
POINT
POINT
POINT
(1) [Controller Setting] and [Ethernet] of GT
Designer3
For [Controller Setting] and [Ethernet] of GT
Designer3, refer to the following.
23.3.1 Setting communication interface
(Communication settings)
(2) Ethernet setting
When connecting Built-in Ethernet port CPU to a
GOT, the setting items for the network No. and
station No. do not exist at the PLC side. However,
these virtual values must be set on the GOT side.
Therefore, set the network No. and station No.
Set the network No. that does not exist on the
network system and any station No.
(1) Controller setting
Item
GOT NET No.
GOT PLC No.
GOT IP Address
GOT Port No. (Communication)
GOT Port No.
(Ethernet Download)
Default Gateway
Subnet Mask
Retry
Startup Time
Timeout Time
Delay Time
(2) Ethernet setting
Item
Host
N/W No.
PLC No.
Ethernet setting
Type
No.1
IP address
Port No.
Communication
*1
Set the same value as that of GOT N/W No.
*2
Set a value different from that of the GOT PLC No. and the
PLC No. of other PLCs on the same network.
*3
In the case of MELSEC iQ-F series, it is FX5CPU.
*4
In the case of MELSEC iQ-F series, it is 5562 (fixed).
*5
In the case of MELSEC iQ-F series, it is TCP (fixed).
Set value (Use default value)
1
1
192.168.0.18
5001
5014
0.0.0.0
255.255.255.0
3times
3sec
3sec
0ms
Set value
*
-
*1
*1
1
1
*2
*2
2
3
*3
*3
RCPU
RCPU
192.168.0.1
192.168.0.2
*4
*4
5006 (fixed)
5006 (fixed)
*5
*5
UDP (fixed)
UDP (fixed)
Advertisement
Chapters
Table of Contents
