Connecting To Ethernet Module (Fx Series) - Mitsubishi Electric GT14 User Manual

Hide thumbs Also See for GT14:
Table of Contents

Advertisement

23.4.11 Connecting to Ethernet module
(FX Series)
This section describes the settings of the GOT and
Ethernet module (FX Series) in the following case of the
system configuration.
POINT
POINT
POINT
Ethernet module (FX Series)
For details of the Ethernet module (FX Series), refer to
the following manual.
FX
-ENET-L User's manual
3U
FX
-ENET-ADP User's manual
3U
System configuration
[Controller Setting] and [Ethernet] of GT Designer3
<Ethernet module> (The settings other than the
following are set to the default)
Network No.
PC No.
IP address
Port No.
Communication
format
 Ethernet parameter settings of FX3U-ENET-L Configuration tool
*1
These setting items do not exist on the PLC side. However,
the virtual values must be set on the GOT side.
 [Controller Setting] and [Ethernet] of GT
Designer3
<GOT>
(The settings other than the
following are set to the default)
PLC No.
: 1
IP address
:
192.168.0.18
Port No.
: 5019
Communication
: TCP (fixed)
format
*1
: 1 (virtual)
*1
: 2 (virtual)
: 192.168.0.19
: 5551
: TCP (fixed)
Ethernet parameter settings of FX
Configuration tool
(1) Ethernet setting
Set the Ethernet parameter with FX
Configuration tool.
For using FX
-ENET-L Configuration tool, install GX-
3U
Developer Ver.8.88S or later on the personal computer.
For details on FX
-ENET-L Configuration tool, refer to
3U
the following manual.
FX
-ENET-L Configuration tool Operation
3U
manual
Item
Module
Module 0
Operational settings
Refer to (2).
Initial settings
(Use default value)
Open settings
Refer to (3).
Router relay parameter
(Use default value)
E-mail settings
: Necessary
*1
Set the number of the Ethernet module.
23. ETHERNET CONNECTION
23.4 PLC Side Setting
-ENET-L
3U
-ENET-L
3U
Setting necessity at
Set value
GOT connection
*1
: As necessary
: Not necessary
23 - 43
17
18
19
20
21
22
23
24

Advertisement

Table of Contents
loading

Table of Contents