Mitsubishi Electric GT14 User Manual page 349


Setting item
The following describes the setting items of the standard I/F setting.(GT14 Handy does not use the extend I/F setting,
RS232 setting.)
Item
Standard I/F Setting
CH No.
I/F
Driver
Detail Setting
18. DRAWING SOFTWARE SETTINGS (CONTROLLER SETTING AND COMMON SETTINGS)
Set channel No. and drivers to the GOT standard interfaces.
Standard I/F-1, Standard I/F-2, Standard I/F-3, Standard I/F-4
Set the CH No. according to the intended purpose.
The number of channels differs depending on the GOT to be used.
0: Not used
1 to 4:
Used for connecting a controller of channel No. 1 to 4 set in Setting connected equipment (Channel setting)
8: GOT(extended computer)
9: Used for connecting Host (PC)
* : Used for gateway function and Ethernet download
Multi: Used for Ethernet multiple connection
The communication type of the GOT standard interface is displayed.
Set the driver for the device to be connected.
• None • Host (PC) • Each communication driver for connected devices
Make settings for the transmission speed and data length of the communication driver.
Refer to each chapter of the equipment to be connected to the GOT.
18.1 Setting the Communication Interface
Description
17
18
19
20
21
22
23
24
18 - 13