Accessing The Plc By Gx Developer, Px Developer, Or Gx Configurator - Mitsubishi Electric GT14 User Manual

31.6.3 Accessing the PLC by
GX Developer, PX Developer,
or GX Configurator
The following shows the procedure to set the FA
transparent function of GX Developer.
GX Configurator is an add-on software of GX Developer.
(Except for GX Configurator-QP)

Connecting the GOT and PLC in direct
connection (when connecting to QCPU (Q
mode))
1.
Click [Online] [Read from PLC] in GX Developer.
2.
Set the [PLC Series] to [QCPU (Q mode)].
3.
The [Transfer Setup] is displayed.
4.
Set the [Transfer Setup]:
PC side I/F: Serial USB (COM)
PLC side I/F: PLC module
Other station: No specification
5.
Double-click [Serial] of the PC side I/F to display [PC
side I/F Serial setting].
6.
Check the following for [PC side I/F Serial Setting].
When connecting the GOT and PC with USB
Mark the [USB] checkbox.
7.
Double-click [PLC module] of the PLC side I/F to display
[PLC side I/F Detailed setting of PLC module].
8.
Check-mark the following in [PLC side I/F Detailed
setting of PLC module].
Direct CPU connection
Mark the [via GOT(direct coupled) transparent mode]
checkbox.
*1 This is the operation required in the case of using GX
Developer of which version is 8.22Y and above.
9.
The screen returns to [Transfer Setup]. Click
to check if GX Developer has been connected to the
QCPU (Q mode).
31. FA TRANSPARENT FUNCTION
31.6 Personal Computer Side Setting
*1
31 - 25
25
26
27
28
29
30
31