37.6 Device Range that Can Be Set
For details on the device range of controllers that can be used on GT14 Handy, refer to the following manuals.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
GOT1000 Series Connection Manual (Non-Mitsubishi Products 1) for GT Works3
37.7 Precautions
Station No. settings of the PLC side
In the system configuration, the PLC with the station number set with the host address must be included. For details
of host address setting, refer to the following.
37.4.1 Setting communication interface (Communication settings)
GOT clock control
The GOT clock function is available only for the PLC with the station number set with the host address.
For details of host address setting, refer to the following.
37.4.1 Setting communication interface (Communication settings)
System Configuration
If the system is configured by mixing the PC3J extended function compliant PLC with the PC3J extended function
incompliant PLC, normal communication may not be performed. Unify the PLCs into PC3J extended function
compliant or PC3J extended function incompliant to configure the system.
System alarm
The system alarm can be displayed only for the PLC set with a host address. When connected to the PC3J extended
function compliant PLC, only the system alarm of program No. 1 can be displayed.
37. CONNECTION TO JTEKT PLC
37.6 Device Range that Can Be Set
32
33
34
35
36
37
38
39
37 - 21