Mitsubishi Electric GT14 User Manual page 494

Hide thumbs Also See for GT14:
Table of Contents

Advertisement

(2) Operational settings
Item
Communication data
(Use default value)
*1
code
IP address
*1
Initial timing
Send frame setting
(Use default value)
TCP Existence
confirmation setting
: Necessary
*1
Because port No. 5551 is fixed, these items operate at the
following setting without relations to the setting given here.
• Communication date code: [Binary code]
• Initial timing setting: [Always wait for OPEN]
(Communication is available while the programmable
controller CPU stops.)
POINT
POINT
POINT
When changing Ethernet parameter
After writing the Ethernet parameter to the PLC CPU,
turn off and then on, or reset the PLC CPU.
23 - 44
23. ETHERNET CONNECTION
23.4 PLC Side Setting
Setting necessity at
Set value
GOT connection
192.168.0.19
: As necessary
: Not necessary
(3) Open settings
Item
Protocol
Open system
MELSOFT connection
Fixed buffer
Fixed buffer
communication procedure
Pairing open
Existence check
(Use default value)
Host station Port No.
(DEC.)
Transmission target device
IP address
Transmission target device
Port No. (DEC.)
POINT
POINT
POINT
When connecting to multiple GOTs and peripheral
devices
The number of protocols equivalent to that of the GOTs
and devices must be set.
Setting necessity at
Set value
GOT connection
TCP

Advertisement

Table of Contents
loading

Table of Contents