Installing When Starting The Got - Mitsubishi Electric GT14 User Manual

17.3.1 Installing when starting the GOT

The displayed message is different depending on the installation condition of standard monitor OS. When the screen
requesting operation is displayed, operate the GOT according to the instructions on the screen.

Operation procedure
(1) When installing with SD card
Now installing BootOS.
Reboot.
17. INSTALLATION OF COREOS, BOOTOS AND STANDARD MONITOR OS
17.3 BootOS and Standard Monitor OS Installation Using SD card or USB Memory
1.
Power OFF the GOT, switch the SD card access
switch to OFF, and install the SD card where the
BootOS, standard monitor OS or project data is
stored in the SD card interface of the GOT.
2.
Switch ON the SD card access switch of GOT.
3.
Power on the GOT while pressing upper left corner
of the GOT screen. (1-point press installation
function)
4.
The BootOS or standard monitor OS is installed in
the built-in flash memory.
The SD card access LED is lit during the install
execution.
Do not pull out the SD card or power off the GOT
while the SD card access LED is lit.
5.
The GOT restarts automatically after the installation
is completed.
(When the standard monitor OS is already installed,
the GOT restarts by touching the [OK] button.)
6.
After confirming normal restart, switch off the SD
card access switch of the GOT. Confirm that the
card access LED is not lit, and remove the SD card
from the SD card interface of the GOT.
17
18
19
20
21
22
23
24
17 - 5