Emc Directive-Compliant System Configuration - Mitsubishi Electric GT14 User Manual

5.2.2

EMC Directive-Compliant System Configuration

The information of the EMC Directive compliant models, contact your local distributor.

GOT
Use any of the following GOTs with which CE mark logo is printed on the rating plate.
When using a GOT other than shown below, the system does not conform to the EMC Directive.
Item
GT14 HandyGOT
Connector Conversion Box
POINT POINT POINT
Checking method of hard ware version.
Confirm the hardware version with the products rating plate.

Connection method
Use the following methods to connect with the GOT to ensure compliance with the EMC Directive.
Direct connection to CPU
Computer link connection
CC-Link connection (via G4)
CC-Link connection (via GT11H(S)-CCL)
Ethernet connection
GOT multi-drop connection
Other connections
*1
POINT POINT POINT
(1) System configuration
GT14 Handy conforms to the EMC Directive only when used in the connection type above, via connector
conversion box.
(2) Connected devices
If connecting to the PLC or microcomputer other than Mitsubishi products
(MELSEC-Q series, MELSEC-L series, MELSEC-QnA , MELSEC-A series or MELSEC-FX series) please
refer to the EMC Directive compliance manual for that specific device.
5 - 4
5. UL, cUL STANDARDS AND EMC DIRECTIVE
5.2 EMC Directive
GT1455HS-QTBDE
GT1450HS-QMBDE
GT16H-CNB-42S
GT16H-CNB-37S
GT11H-CNB-37S
MITSUBISHI ELECTRIC CORPORATION
Connection method
When connecting the GOT to other controllers as a PLC manufactured by other company, create the cable (by the user) and
configure the system to meet the EMC Directive specifications for the connected device.
Model
Hardware version B or later
Hardware version D or later
AA
Hardware Version
: Compliant with EMC Directive
*1
Version
-
-
: Not compliant with EMC Directive
GT14 Handy
*1