Mitsubishi Electric GT14 User Manual page 103


Installation with the mounting fixtures
(1) Installing the mounting fixtures
Install the supplied mounting fixtures to the connector conversion box.
Tighten the mounting screws within the specified torque range.
Tightening torque
Mounting bracket (accessory)
(1) Installing on the panel face
Install the connector conversion box on the panel face (mounting surface).
Drill a mounting slot of the following size on the panel face.
Tighten the mounting screws within the specified torque range.
Tightening torque
M4 screw and nut
x 4sets
(prepared by user)
0.49 to 0.68N•m
Mounting screw (accessory)
M3×3
0.69 to 0.88N•m
connector
conversion box
3-4.5
10
Mounting bracket
20
6. OPTION
6.6 Connector Conversion Box
1
2
3
4
5
6
7
8
Unit: mm
6 - 31