Download  Print this page

System Configuration; Enlarged View Of Connectors - Mitsubishi Electric F930GOT-BWD-E User Manual

Graphic operation terminal.
Hide thumbs

Advertisement

Graphic Operation Terminal F930GOT
1.5

System configuration

This paragraph describes connection of the GOT to a PLC and peripheral unit.
1.5.1

Enlarged view of connectors

A PLC and peripheral unit can be connected to the following connectors in the GOT.
1) Connectors in the GOT
Connectors are provided on the rear face of the GOT.
PLC connector (RS-422 connector) D-sub, 9-pin, female
This connector allows communication with an FX/A Series PLC.
PC connector (RS-232C connector), D-sub, 9-pin, male
This connector links a personal computer having the screen data created using the screen
creation software to allow data transfer.
When the RS-232C connector in the PC is the 9-pin type, use a data transfer cable FX-
232CAB-1. When the RS-232C connector in the PC is the half-pitch, 14-pin type, use a data
transfer cable FX-232CAB-2.
This connector is used also when the FX
1:N connection is adopted with "CPU PORT" in an FX/A Series PLC.
* When a PLC is connected via a computer link unit, use either of the connectors

-232-BD is used for an FX
2N
Introduction 1
Series PLC or when
2N
or
above.
1-7

Advertisement

Table of Contents

   Also See for Mitsubishi Electric F930GOT-BWD-E

   Related Manuals for Mitsubishi Electric F930GOT-BWD-E

Comments to this Manuals

Symbols: 0
Latest comments: