Mitsubishi Electric GT14 User Manual page 97


Installation
The Connector Conversion Box can be installed on the panel face directly or with mounting bracket offered as an
accessory.
(1) Direct mounting on the panel face
Drill a mounting slot of the following size on the panel face.
18 (0.7") 28 (1.1")
Panel cut area
Unit: mm (inch)
(2) Mounting on the panel face
Fit the Connector Conversion Box from the back side of the panel face, and fix it with four M3
screws (prepared by user).
In the Connector Conversion Box, thread of M3, 6 mm in depth is cut in each mounting hole.
Prepare four M3 mounting screws separately while considering the thickness of the panel face.
Tighten the mounting screw with the specified torque.
Tightening torque
Make sure that interfering objects are not located within 100 mm from the rear face so that the connector of a
PLC cable is not hindered.
To wire the terminal block, keep a space of 25 mm or more on both sides of the Connector
Conversion Box.
18 (0.7")
Drill 4-3.5
0.49 to 0.68 N/m
Thread depth 25
6 (0.23") (0.98")
100 (3.93")
6.6 Connector Conversion Box
25
(0.98")
6 - 25
6. OPTION
1
2
3
4
5
6
7
8