Led Settings Of Grip Switch - Mitsubishi Electric GT14 User Manual

9.4.8

LED settings of grip switch

Grip switches (DSW1, DSW2) contain green LED for checking operation.The grip switch LED coordinates with b6 of the
external input and output function/output information (read device +1) and operates the LED ON/OFF display.

Allocation of device to control LED
The device to control LED is allocated by the drawing software. The external input and output function/output
information (read device +1) set in [read device] of [system information function] in the [common settings] is allocated
to the LED control.
The LED control for the grip switch is allocated to b6 (7th bit from the lower) of the device allocated to the external
input and output function/output information. The LED is lit when the bit value is 1 and not
lit when the bit value is 0.
External input and output function/output information (read device +1)
b15 b14 b13
For example, when D100 is set in the read device of system information, the value in b6 of D101 is reflected to the LED lit/
not lit.
9.4.9 Keylock switch (2-position SW)
The keylock switch (2-position SW) is used with wiring to the input of PLC

Connection example
The following describes the connection example when the notch of the switch is set to the left.
Set the load up to 24VDC/1A (contact specification) for each contact.
Notch of
the switch is
set to the left
(1) When using the connector conversion box (GT16H-CNB-42S)
GT14 Handy
KSW-C
KSW-1
KSW-2
(2) When using the connector conversion box (GT11H-CNB-37S or GT16H-CNB-37S)
GT14 Handy
KSW-C
KSW-1
KSW-2
b12 b11 b10 b9 b8
Connector conversion box
Connector conversion box
9. HANDLING OF POWER WIRING AND SWITCH
b7 b6 b5
Grip switch
PLC
Terminal
block 2)
8
COM
9
X20
10
X21
PLC
Terminal
block 2)
6
COM
5
X20
4
X21
9.4 Switch Wiring
b4 b3 b2 b1 b0
9 - 21
9
10
11
12
13
14
15
16