Mitsubishi Electric GT14 User Manual page 91

HINT HINT HINT
Example of the station No. switching setting procedure using the ID recognition function of the connector
conversion box.
The following shows an example of the station No. switching setting procedure using the ID recognition function of
the connector conversion box. Here, an example to set the station No. switching device value using the status
observation function is explained.
1.
Set the ID number of the connector conversion box.
The ID number of the connector conversion box will be the PC No. of the PLC to be monitored.
(1) Setting the ID number
2.
Switch the serial communication interface of the Handy GOT.
Open the environment protection cover on the back of the main unit and connect the PLC communication cable
connector to the Ethernet connector to establish the Ethernet communication.
Configuring the setting above enables the communication with the connector conversion box as well.
3.
Install the communication driver to the handy GOT.
Install the Ethernet communication driver to be used in the communication with the controllers and the MODBUS/
RTU communication driver to be used in the communication with the connector conversion box to the handy GOT.
(2) GOT side settings
4.
Make the controller settings of the project data to be transferred to the handy GOT.
• Controller setting
Make the settings to connect the GOT to Ethernet.
Make the MODBUS/RTU communication settings using RS232 to connect the GOT to the connector conversion
box.
6. OPTION
6.6 Connector Conversion Box
1
2
3
4
5
6
7
8
6 - 19